turbosound sub's

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • nightline
    • Oct 2002
    • 1001
    #16
    En het merk.....?
    Powered by AudioMadness....

      Comment

      • dj pier
        • Feb 2008
        • 14
        #17
        in de turbosound bas tsw 718 zit de speaker ls-1804

        het speaker merk en de waarden er van die ik er in steek is

        PRECISION DEVICES
        PD1850 Technical Information
        [LEFT]Nominal Diameter 46cm (18") Power rating 800 Watts Frequency range 35 - 2000 Hz Nominal Impedance 8 Ohms Sensitivity (1 W 1 M) 98 dB Highest Recommended Crossover 400 Hz Resonance 30 Hz Enc. Vol. Recommended 90 to 220 Litres Effective Piston Diameter 382 mm (15.05”) Displacement limit 32 mm (1.26”) Voice coil diameter 127 mm (5”) Voice coil Copper Voice coil winding depth 28 mm (1.1”) Voice coil wire length 48.9M (160.5’) Magnet gap depth 11.5 mm (0.453”) Magnet material/mass Ceramic/4.8 Kg (170 oz.) Magnetic assembly total mass 17.27 Kg (38 Lbs.) Flux Density 11,800 Gauss BL product 31.57 Tesla/M Effective Moving Mass 216.4 grams Connectors Spring loaded push button metal bodied Polarity Positive Voltage on Red Terminal gives forward cone motion Thiele-Small Parameters Fs 30 Hz Xmax 11.25 mm Revc 5.4 Ohms Vd 13 x 10-4 m3 Qts 0.21 No 2.88% Qms 6.04 Pmx 800 Watts Qes 0.22 Cms 133 µM/N Vas 249 Litres Mms 216.4 grams Sd 1150 sq cm BL 31.57 T/m [/LEFT]
        Last edited by dj pier; 20-02-08, 19:43.

          Comment

          • Turboke
            • Oct 2006
            • 463
            #18
            Ja maar geef ons nu de waarden van de 1804 van turbosound eens.

              Comment

              • dj pier
                • Feb 2008
                • 14
                #19
                dit zijn de waarden die ik van een collega gekregen heb deze vind je niet op het net deze wilt ook anoniem blijven

                [FONT=Arial]LS-1804[/FONT]
                [FONT=Arial]TYPICAL CHARACTERISTICS[/FONT]



                [FONT=Arial]Rated impedance[/FONT]

                [CENTER][FONT=Arial]Z[/FONT][/CENTER]


                [CENTER][FONT=Symbol]W[/FONT][/CENTER]


                [CENTER][FONT=Arial]8[/FONT][/CENTER]

                [FONT=Arial]Half space sensitivity (1W@1m)[/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]dB SPL[/FONT][/CENTER]


                [CENTER][FONT=Arial]98[/FONT][/CENTER]

                [FONT=Arial]Usable freq. range[/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]Hz[/FONT][/CENTER]


                [CENTER][FONT=Arial]30-1000[/FONT][/CENTER]

                [FONT=Arial]Power handling capacity (AES)[/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]W[/FONT][/CENTER]


                [CENTER][FONT=Arial]800[/FONT][/CENTER]

                [FONT=Arial]Max Sound Pressure Level[/FONT]

                [CENTER][FONT=Arial]SPLmax[/FONT][/CENTER]


                [CENTER][FONT=Arial]dB SPL[/FONT][/CENTER]


                [CENTER][FONT=Arial]122[/FONT][/CENTER]

                [FONT=Arial]Min. impedance modulus[/FONT]

                [CENTER][FONT=Arial]Zmin[/FONT][/CENTER]


                [CENTER][FONT=Symbol]W[/FONT][FONT=Arial]@Hz[/FONT][/CENTER]


                [CENTER][FONT=Arial]7.0@200[/FONT][/CENTER]

                [FONT=Arial]Voice-coil inductance @ 1kHz[/FONT]

                [CENTER][FONT=Arial]Le1k [/FONT][/CENTER]


                [CENTER][FONT=Arial]mH[/FONT][/CENTER]


                [CENTER][FONT=Arial]1,71[/FONT][/CENTER]

                [FONT=Arial]Voice-coil inductance @ 10kHz[/FONT]

                [CENTER][FONT=Arial]Le10k[/FONT][/CENTER]


                [CENTER][FONT=Arial]mH[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,82[/FONT][/CENTER]

                [FONT=Arial]BL product[/FONT]

                [CENTER][FONT=Arial]BL[/FONT][/CENTER]


                [CENTER][FONT=Arial]N/A[/FONT][/CENTER]


                [CENTER][FONT=Arial]22,7[/FONT][/CENTER]

                [FONT=Arial]Moving mass[/FONT]

                [CENTER][FONT=Arial]Mms[/FONT][/CENTER]


                [CENTER][FONT=Arial]kg[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,180[/FONT][/CENTER]


                [FONT=Arial]THIELE-SMALL PARAMETERS: TYPICAL (QC LIMITS)[/FONT]


                [FONT=Arial]Resonance frequency[/FONT]

                [CENTER][FONT=Arial]Fs[/FONT][/CENTER]


                [CENTER][FONT=Arial]Hz[/FONT][/CENTER]


                [CENTER][FONT=Arial]34(±5)[/FONT][/CENTER]

                [FONT=Arial]DC Resistance[/FONT]

                [CENTER][FONT=Arial]Re[/FONT][/CENTER]


                [CENTER][FONT=Symbol]W[/FONT][/CENTER]


                [CENTER][FONT=Arial]5.5(±0.5)[/FONT][/CENTER]

                [FONT=Arial]Mechanical quality factor[/FONT]

                [CENTER][FONT=Arial]Qms[/FONT][/CENTER]


                [CENTER][FONT=Arial]1[/FONT][/CENTER]


                [CENTER][FONT=Arial]4,8[/FONT][/CENTER]

                [FONT=Arial]Electrical quality factor[/FONT]

                [CENTER][FONT=Arial]Qes[/FONT][/CENTER]


                [CENTER][FONT=Arial]1[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,41[/FONT][/CENTER]

                [FONT=Arial]Total quality factor[/FONT]

                [CENTER][FONT=Arial]Qts[/FONT][/CENTER]


                [CENTER][FONT=Arial]1[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,38[/FONT][/CENTER]

                [FONT=Arial]Mechanical suspension compliance[/FONT]

                [CENTER][FONT=Arial]Cms[/FONT][/CENTER]


                [CENTER][FONT=Arial]10-6.m/N[/FONT][/CENTER]


                [CENTER][FONT=Arial]115[/FONT][/CENTER]

                [FONT=Arial]Effective piston area[/FONT]

                [CENTER][FONT=Arial]Sd[/FONT][/CENTER]


                [CENTER][FONT=Arial]m2[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,128[/FONT][/CENTER]

                [FONT=Arial]Equivalent Cas air load[/FONT]

                [CENTER][FONT=Arial]Vas[/FONT][/CENTER]


                [CENTER][FONT=Arial]m3[/FONT][/CENTER]


                [CENTER][FONT=Arial]0,260[/FONT][/CENTER]

                [FONT=Arial]Max linear excursion[/FONT]

                [CENTER][FONT=Arial]Xmax[/FONT][/CENTER]


                [CENTER][FONT=Arial]±mm[/FONT][/CENTER]


                [CENTER][FONT=Arial]8,0[/FONT][/CENTER]

                [FONT=Arial]Linear displacement volume[/FONT]

                [CENTER][FONT=Arial]Vd[/FONT][/CENTER]


                [CENTER][FONT=Arial]10-3.m3[/FONT][/CENTER]


                [CENTER][FONT=Arial]1,024[/FONT][/CENTER]

                [FONT=Arial]Reference efficiency[/FONT]

                [CENTER][FONT=Symbol]h[/FONT][FONT=Arial]0[/FONT][/CENTER]


                [CENTER][FONT=Arial]%[/FONT][/CENTER]


                [CENTER][FONT=Arial]2,5[/FONT][/CENTER]

                [FONT=Arial]Unity load volume[/FONT]

                [CENTER][FONT=Arial]Vas.Qts2[/FONT][/CENTER]


                [CENTER][FONT=Arial]10-3.m3[/FONT][/CENTER]


                [CENTER][FONT=Arial]41,4[/FONT][/CENTER]


                [FONT=Arial]ABSOLUTE MAXIMUM RATINGS[/FONT]



                [FONT=Arial]Short term max. input voltage[/FONT]

                [CENTER][FONT=Arial]Vmax[/FONT][/CENTER]


                [CENTER][FONT=Arial]V[/FONT][/CENTER]


                [CENTER][FONT=Arial]160[/FONT][/CENTER]

                [FONT=Arial]Max.excursion before damage[/FONT]

                [CENTER][FONT=Arial]Xdam[/FONT][/CENTER]


                [CENTER][FONT=Arial]±mm[/FONT][/CENTER]


                [CENTER][FONT=Arial]16[/FONT][/CENTER]

                [FONT=Arial]Ambient operating temperature[/FONT]

                [CENTER][FONT=Arial]Ta[/FONT][/CENTER]


                [CENTER][FONT=Arial]°C[/FONT][/CENTER]


                [CENTER][FONT=Arial]-10 to +50[/FONT][/CENTER]

                [FONT=Arial]Storage temperature[/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]°C[/FONT][/CENTER]


                [CENTER][FONT=Arial]-20 to +70[/FONT][/CENTER]

                [FONT=Arial]Environemental withstanding [/FONT][FONT=Times New Roman][FONT=Zapf Dingbats]Q[/FONT][/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]Outdoor [/FONT][FONT=Times New Roman][FONT=Zapf Dingbats]:[/FONT][/FONT][/CENTER]


                [FONT=Arial]APPLICATION INFORMATION[/FONT]



                [FONT=Arial]Air volume occupied by the driver[/FONT]

                [CENTER][FONT=Arial]-[/FONT][/CENTER]


                [CENTER][FONT=Arial]10-3.m3[/FONT][/CENTER]


                [CENTER][FONT=Arial]6,9[/FONT][/CENTER]

                [FONT=Arial]Speaker net mass[/FONT]


                [CENTER][FONT=Arial]kg[/FONT][/CENTER]


                [CENTER][FONT=Arial]10,9[/FONT][/CENTER]

                [FONT=Arial]Recommended reflex box[/FONT]

                [CENTER][FONT=Arial]Vb/Fb[/FONT][/CENTER]


                [CENTER][FONT=Arial]Lts/Hz[/FONT][/CENTER]


                [CENTER][FONT=Arial]250L / 35Hz[/FONT][/CENTER]
                Mgv björn
                Last edited by dj pier; 21-02-08, 07:20.

                  Comment

                  • baske
                    • Mar 2008
                    • 2
                    #20
                    collega

                    hey als die collega je da gegevens van zon speaker kan bezorgen kan hij je toch ook wel een shema van de kast bezorgen of heeft hem zelf zo geen kasten

                      Comment

                      Previous 1 2 template Next
                      Working...